Do Prime And Paint Cut Ends Of Truwood Siding

Additional primer is not needed field painting guidance for best results with our primed siding products.

Do prime and paint cut ends of truwood siding.

Back priming helps prevent paint from peeling by reducing the amount of water vapor that passes through the wood. Once the siding has been installed apply two coats of a top of the line latex exterior house paint to it. Do not miter sides edges of trim. Roof and gutters are adjacent to the siding.

When back priming be sure to prime the ends of each piece after it has been cut to fit since end grain will absorb the most moisture. Spray cans or primer or disposable cans and brushes with primer can be used to prime the end grain once installed. Provide a 1 in. Make sure to prime and paint all cut edges.

According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate. Cutting cut with conventional tools into the face to be exposed. Do not bevel cut the siding edges at butt joints. Use high quality waterborne 100 acrylic exterior paints apply a finish coat within 180 days of installation do not paint wet siding ensure the surface is clean dry and free of any dust dirt or mildew do not use.

Make sure to prime and paint all exposed cut edges. All it takes is a little can of paint or sealer. Do not paint in wet or cold conditions. Priming and sealing end grain during the wood siding deck or trim installation can be easily accomplished and does little to slow down a job.

Clearance between the gutter end and trim see fig. The back side is better left unpainted. Therefore do not prime the back side of the siding or trim. 2018 2015 2012 2009 international.

I would strongly suggest priming the front back edges and ends of your pine siding with an oil based exterior primer before installation.